Measurements of heat release of diesel PM for advanced thermal management strategies for DPF regeneration

Hwan S. Chong, Suresh K. Aggarwal*, Kyeong O. Lee, Seung Yeon Yang

*Corresponding author for this work

Research output: Contribution to journalArticlepeer-review

9 Scopus citations

Abstract

Diesel engines typically require diesel particulate filter (DPF) systems to reduce particulate matter (PM) emissions in order to meet increasingly stringent emission regulations. While there have been noticeable advances in DPF technology, significant efforts are still needed to develop optimum DPF regeneration strategies and achieve efficient removal of diesel PM. In particular, the development of an effective thermal management system is essential to prevent the potential failure of the DPF system by the thermal runaway during soot oxidation in DPF regeneration. In an effort to develop optimum thermal management strategies, this experimental investigation is concerned primarily with measuring the instantaneous rate of heat generation as well as the total amount of heat released during the oxidation of diesel PM containing different concentrations of soluble organic fraction (SOF). The experimental approach was to measure directly, by means of a differential scanning calorimeter (DSC), the amount of heat release during the thermal reactions of diesel PM with air and to elucidate differences in the heat release characteristics of diesel PM and surrogate (model) soot. The diesel samples were collected from a cordierite particulate filter, where PM emissions bypassing the exhaust pipe of a light-duty diesel engine were deposited. Furthermore, a thermogravimetric analyzer (TGA) was used to obtain dry diesel soot samples with no volatile components present. The DSC experiments revealed that the amounts of heat released from the oxidation of SOF-containing diesel PM sample, dry diesel soot, and surrogate soot were approximately 14.67 kJ/g, 17.3 kJ/g, and 14.02 kJ/ g, respectively, indicating that the largest heat release was obtained from the dry diesel soot sample. Results also indicated significant differences in the temporal rates of heat release in the oxidation of SOF-containing diesel PM, dry diesel soot, and surrogate soot. In particular, significant differences were found on the results for dry diesel soot samples with respect to the oxidation temperatures of 550°C and below 550°C in air. The heat release rate profile for the 550°C case exhibited a continuous sharp decrease after the peak value, while those for the 535°C and 525°C cases indicated first a sharp decrease, followed by slow and then sharp decrease again. The present experimental data are expected to lead to better predictive tools for thermal energy distribution during DPF regeneration, and thus the development an optimum thermal management system for DPF systems.

Original languageEnglish (US)
Pages (from-to)1328-1341
Number of pages14
JournalCombustion Science and Technology
Volume183
Issue number12
DOIs
StatePublished - Dec 1 2011

Keywords

  • DPF regeneration
  • Diesel particulate matter
  • Heat release rate measurements

ASJC Scopus subject areas

  • Physics and Astronomy(all)
  • Chemical Engineering(all)
  • Energy Engineering and Power Technology
  • Fuel Technology
  • Chemistry(all)

Fingerprint

Dive into the research topics of 'Measurements of heat release of diesel PM for advanced thermal management strategies for DPF regeneration'. Together they form a unique fingerprint.

Cite this