In our previous paper, a new gas exchange concept termed Divided Exhaust Period Regulated 2-stage (DEP R2S) system has been proposed. In this system, two exhaust valves in each cylinder are separately functioned with one valve feeding the exhaust mass flow into the high pressure (HP) manifold whilst the other valve evacuating the remaining mass flow directly into the low pressure (LP) manifold. By adjusting the timing of the exhaust valves, the target boost can be controllable whilst improving the engine's pumping work and scavenging is attainable which results in better fuel efficiency from the gas exchange perspective. This paper will continue this study by adding an appropriate knock model to examine the benefits this concept could bring to the combustion phasing. The results at full load showed that under knock limited spark advance (KLSA) and fully optimized exhaust valve timing condition, the DEP R2S system benefited from lower pumping loss and better scavenging due to the reduced backpressure and improved pulsation interference despite suffering from reduced expansion ratio and expansion work. The combustion phasing was advanced across the engine speed which is mainly attributed to the reduced residual and the reduced requirement of gross IMEP. The net BSFC was observed to improve by up to 3% depending on the engine operating points. At part load, the DEP R2S system could be used as a mechanism to extend the 'duration' of the exhaust valve. This will reduce the recompression effect of the exhaust residuals during the beginning and the end of the exhaust stroke compared to the original R2S model with late exhaust valve opening and early exhaust valve opening. In addition, increased internal EGR due to the increased overlap between the LP and the intake valve is also beneficial for the improved PMEP as the throttle can be further opened to reduce the corresponding throttling loss. The average net BSFC improvement is expected to be approximately 6-7%.
|Original language||English (US)|
|Title of host publication||Proceedings of the ASME Turbo Expo|
|Publisher||American Society of Mechanical Engineers (ASME)firstname.lastname@example.org|
|State||Published - Jan 1 2015|