Pre-ignition in SI engine is a critical issue that needs addressing as it may lead to super knock event. It is widely accepted that pre-ignition event emanates from hot spot(s) that can be anywhere inside the combustion chamber. The location and timing of hotspot is expected to influence the knock intensity from a pre-ignition event. In this study, we study the effect of location and timing of hot spot inside the combustion chamber using numerical simulations. The simulation is performed using a three-dimensional computational fluid dynamics (CFD) code, CONVERGE™. We simulate 3-D engine geometry coupled with chemistry, turbulence and moving structures (valves, piston). G-equation model for flame tracking coupled with multi-zone model is utilized to capture auto-ignition (knock) and solve gas phase kinetics. A parametric study on the effect of hot spot timing and location inside the combustion chamber is performed. The hot spot timing considered are -180 CAD, -90 CAD and -30 CAD and the locations of the hot spots are in the center and two edges of the piston surfaces. Simulation results for normal combustion cycle are validated against the experimental data. The simulation results show great sensitivity to the hot spot timing, and the influence of local temperature gradient is noted to be significant. In case of early hot spot timing of -180 CAD, the pre-ignition event did not lead to super knock. Nevertheless, at late hot spot timing, super knock was realized. On the other hand, the effect of hot spot location on pre-ignition event depends on the geometry of the combustion chamber.