Combined impact of branching and unsaturation on the autoignition of binary blends in a motored engine

Dongil Kang, Stephen R. Kirby, John Ramiro Agudelo, Magín Lapuerta, Khalid Al-Qurashi, André Louis Boehman

Research output: Contribution to journalArticlepeer-review

12 Scopus citations

Abstract

The impact of a branched and unsaturated compound (diisobutylene) mixed with simple hydrocarbons such as n-heptane and isooctane in binary blends on the autoignition behavior were investigated in a modified cooperative fuel research (CFR) engine at an equivlanece ratio of 0.5 and intake temperature of 120 °C. From this test condition, a homogeneous charge of fuel and intake air can be achieved. The test fuels were prepared by addition of 5-20 vol % diisobutylene into n-heptane and isooctane. The engine compression ratio (CR) was gradually increased from the lowest point to the point where significant high temperature heat release (HTHR) was observed, and this point is also referred to as the critical compression ratio (CCR). Heat release analysis showed that each n-heptane blend had a noticeable low temperature heat release (LTHR), which was not observed in the isooctane blends. The gradual addition of diisobutylene into each primary reference fuel contributed to retarded high temperature heat release in these binary blends, increasing the in-cylinder temperature and decreasing formation of CO. The 15 and 20 vol % blends of diisobutylene in isooctane were not able to reach high temperature heat release in the CFR engine system under these test conditions. The fundamental ignition behavior such as CCR and calculated % LTHR show the impact of the presence of the C-C double bond on ignition reactivity. Species concentration profiles obtained in condensed products from the engine exhaust were measured via gas chromatrography-mass spectrometry and -flame ionization detector. The major intermediate species for each blend were captured at a compression ratio selected just before the high temperature heat release was observed. Most intermediate species were derived from n-heptane and isooctane, while diisobutylene rarely participated in forming any major species, with the exception of the formation of 4,4-dimethyl-2-pentanone. Addition of diisobutylene exhibited opposite trends with regard to the abundance of intermediate species when blended with n-heptane versus with isooctane, due to the different degree of oxidation reactivity of n-heptane in comparison to isooctane.
Original languageEnglish (US)
Pages (from-to)7203-7215
Number of pages13
JournalEnergy & Fuels
Volume28
Issue number11
DOIs
StatePublished - Oct 15 2014

ASJC Scopus subject areas

  • Energy Engineering and Power Technology
  • Chemical Engineering(all)
  • Fuel Technology

Fingerprint Dive into the research topics of 'Combined impact of branching and unsaturation on the autoignition of binary blends in a motored engine'. Together they form a unique fingerprint.

Cite this